Using Checksum to Guess Message Length: Not a Good Idea!

[This article was first published on R – Exegetic Analytics, and kindly contributed to R-bloggers]. (You can report issue about the content on this page here)
Want to share your content on R-bloggers? click here if you have a blog, or here if you don't.

A question posed by one of my colleagues: can a checksum be used to guess message length? My immediate response was negative and, as it turns out, a simple simulation supported this knee-jerk reaction.

Here’s the situation: a piece of software has been written to process a stream of messages. Each message is a sequence of bytes, where the length of the sequence varies, and is terminated by a checksum byte, which is calculated as the cumulative bitwise XOR of the message bytes. There is no header information specifying the length of the sequence. Is it possible to use the checksum byte to locate the end of each message?

It seems like this might just be feasible. But there’s a problem: a coincidental match would cause a premature end to a message. To illustrate this point, let’s look at an example. Consider a message composed of the following series of bytes:

154  59 161 111 127 182 227  37   8 170 194

Now look at the checksums generated from the message as each new byte arrives.

    154 161   0 111  16 166  69  96 104 194

The first byte in the message is 154, so the checksum is just 154. The second byte in the message is 59, which doesn’t match the checksum so we proceed to recalculate the checksum for the first two bytes, which is now 161. The third byte in the message is 161, which just happens to match the checksum! If we were using the checksum to determine the message length then we’d (wrongly) conclude that the message had come to an end.

Our ad hoc method for determining message length would have failed for this message in particular. But there would also be a knock-on effect because failing to correctly identify the end of one message would also mean incorrectly identifying the beginning of the next message, so the whole sequence of messages and checksums would get out of whack. That’s a far bigger problem. In the interests of simplicity we’ll just focus on the failure rate for a single message.

The quickest way to estimate the failure rate for our ad hoc system is simulation. I generated a population of randomised messages of increasing length and then calculated the expected failure rate as a function of message length. The results are plotted below with the message length on the x-axis and probability of falsely identifying a byte in the message as the checksum byte on the y-axis. The blue like is the average failure rate from the simulations and the orange band represents the 95% binomial confidence interval. I consolidated all failures per message. So, for example, it’s possible that a particular message might have more than one point at which the checksum byte could be mistaken. This is simply counted as a single failure.

checksum-error-rate

According to these results, the likelihood of failure is relatively small if the messages are short. For example, a messsage of 16 bytes would have a 6% failure rate. However, as the messages get longer the likelihood of mistakenly identifying a checksum byte escalates significantly. By the time that the message is 256 bytes long the likelihood of a mistake is 65%. So for messages of practical lengths this is not going to be a feasible proposition.

The post Using Checksum to Guess Message Length: Not a Good Idea! appeared first on Exegetic Analytics.

To leave a comment for the author, please follow the link and comment on their blog: R – Exegetic Analytics.

R-bloggers.com offers daily e-mail updates about R news and tutorials about learning R and many other topics. Click here if you're looking to post or find an R/data-science job.
Want to share your content on R-bloggers? click here if you have a blog, or here if you don't.

Never miss an update!
Subscribe to R-bloggers to receive
e-mails with the latest R posts.
(You will not see this message again.)

Click here to close (This popup will not appear again)